Table of Contents
Table of Contents
Implement Profile settings are important for accurate performance of John Deere AMS applications, such as AutoTrac.
NOTE: If AMS applications, such as AutoTrac, are used on a GreenStar 3 2630 Display, then Implement Profile settings do not need to be set up on this display.
NOTE: Cycle the machine key and allow the CommandCenter to power down when connecting or disconnecting ISOBUS implements.
Select an implement type for more information:
Planter - SeedStar 2 and SeedStar 3
Air Seeder - SeedStar 2 and SeedStar 3
Implement ISOBUS Control Unit (Section Control Unsupported)
John Deere Rate Controller 2000
Yield Documentation, Specialty Crop
Manure Constituent Sensing / Slurry Applicator
Select Save button to store settings from all tabs and close Implement Profile application. Selecting Save is not required when switching between tabs.
Implement Profile settings are saved in the display according to the following factors:
Profile Name
ISO Name of the detected implement control unit
NOTE: Set up pre-operation settings in the implement control unit, such as drive configuration, before configuring Implement Profile settings.
ISO Name changes when some implement control unit settings change. This includes changing control unit setup between fertilizer and seeding.
If an implement control unit is connected, the implement control unit automatically sets some Implement Profile settings.
An alert stating "Implement Profile Created" is displayed the first time the control unit is connected. When the implement is reconnected, it is identified by its ISO Name. Implement Profile settings that are saved in the display are then loaded.
NOTE: The alert continues to appear if "Setup Later" is selected.
To view currently detected ISO Name, select Diagnostics Center > control unit Diagnostics tab > choose implement control unit > control unit Info tab.
Verify all required settings before operation. Work Point is not set automatically.