Table of Contents

GreenStar Rate Controller Dry

NOTE: Set up GreenStar Rate Controller Dry in ISOBUS VT before configuring Implement Profile settings.

When a GreenStar Rate Controller Dry is connected, the controller automatically sets some Implement Profile settings. Refer to Implement Profile Overview for additional theory of operation.

To complete setup, enter the following information:

Select Implement

Select an implement from the list of connected implements. If an implement is not listed, select Add Implement to create a profile.

Controller Settings

Displays the implement working width and the number of bins configured for the GreenStar Rate Controller Dry in ISOBUS VT.

Work Point

In-line distance from connection point to point where product is applied.

The following applications require Work Point setting:

Instructions for Measuring Work Point

Mechanical Delay

Mechanical delay is the average time for the product to reach the ground after an ON or OFF command. It may need to change with each machine, implement, and display combination. Set a mechanical delay for each bin on multi-bin spreaders.

The following applications require Mechanical Delay settings:

Instructions for Measuring Mechanical Delay

Connection Type

Connection type, or hitch, describes how implement is attached to machine and controls how display determines implement movement behind the machine.

NOTE: Connection offset measurements are entered in Machine Profile.

The following applications require Connection Type setting:

Drawbar

Rear 3-Point

Front 3-Point

Wagon-Hitch

Ball

Clevis

Hitch-Hook

Piton

 

Pivot Offset

Some implements have a pivoting hitch that connects to the machine's rear 3-point hitch. The offset for this pivoting location is required for the display to determine implement movement behind the machine.

NOTE: Pivot offset setting is available when rear 3-point is selected as the connection type.

Instructions for Measuring Pivot Offset

Lateral Offset

Lateral distance from center point of the machine to center point of the working width of the implement.

The following applications require Lateral Offset setting:

Instructions for Measuring Lateral Offset

Center of Rotation

In-line distance from connection point to implement’s center of rotation while in working position. Usually this is where load bearing parts of implement make contact with the ground.

Center of Rotation offset is important to accurately model trailing action of implement around curves.

NOTE: This offset is NOT needed if Connection Type is set to Front 3-point or Non-Pivoting Rear 3-point.

The following applications require Center of Rotation setting:

NOTE: Measure center of rotation while the implement tool is engaged.

Instructions for Measuring Center of Rotation

Reset Implement Profile

Select Reset Profile button to delete current implement profile settings.

If an implement is connected, settings stored on the implement controller are loaded to the display.

NOTE: If implement profile fails to load properly, select Reset Profile button to reload settings.