Quick Links
Quick Links
|
Fill Prerequisites show which requirements are met for meter activation and any errors that are detected. |
Fill Prerequisites |
|
Close— closes this page without continuing with the procedure. |
Close |
|
Fill Inactive— button appears until all the requirements are met. |
Fill Inactive |
|
Fill Ready— button appears when all the requirements are met. |
Fill Ready |
|
Fill Active— button appears when the meters are rotating. |
Fill Active |
|
Check Mark— indicates that the requirement is met. |
Check Mark |
|
Exclamation Point— indicates that a requirement is not met or that there is an error. |
Exclamation Point |
The implement must be raised.
The implement must be stationary.
Electric power generation (EPG) must be active (PTO engaged for the tractor power generation and hydraulics functional for the implement power generation).
Active faults must not be present for row unit controllers or motor.
|
View Fault— opens Diagnostics | Row Unit Controller (RUC) Row Addressing to view the active fault. |
View Fault |
The vacuum must be at the operating level.
|
Close— closes this page without continuing with the procedure. |
Close |
Verify that seed is in the row unit hoppers, seed disks are installed, and the seed meter is prepared according to the recommendations in your implement Operator's Manual.
Adjust the implement to meet all the requirements.
|
ON/OFF |
NOTE: The toggle button does not appear when the requirement is met.
CAUTION: To avoid injury from rotating components:
Keep all seed meter components in place during operation.
Shut off all seed meters and drives before cleaning or inspection.
|
Fill Ready |
NOTE: The seed meters rotate for 3 seconds. Depending on the meter setup, 3 seconds might not complete the fill process. Select Fill as many times as necessary. Two fill cycles are typically adequate.
|
Advanced Settings— access further adjustments and less common settings. |
Advanced Settings |
