Quick Links
Quick Links
Diagnostics | Meter shows the drive status, which requirements are met for drive activation, and errors that are detected.
|
Engaged— all the requirements are met. The seed meters are engaged. |
Engaged |
|
Error Detected— messages appear for conditions other than electronic power generation (EPG) activation, frame position, wheel motion, and speed. |
Error Detected |
|
Not Ready— no status is recognized until the EPG is active. Engage the power generation system. |
Not Ready |
|
Ready— electric power generation is active. The implement is not lowered and has not met the speed requirement. |
Ready |
|
Ready— EPG is active and the implement is lowered. The speed requirement is not met. |
Ready |
|
Ready— EPG is active and the speed requirement is met. The implement is not lowered. |
Ready |
|
Commanded Off— all sections are off using Section Control even though all drive requirements are met. |
Commanded Off |
NOTE: Multiple gray areas are highlighted as conditions are met.
|
Check Mark— indicates that the requirement is met. |
Check Mark |
|
Exclamation Point— indicates that the requirement is not met or that there is an error. |
Exclamation Point |
NOTE: The meter status is updated as the requirements are met.
|
Diagnostics— directs to EPG Diagnostics when an EPG fault is present. |
Diagnostics |
The ground speed must be greater than 2.1 km/h (1.3 mph).
The implement must be lowered. Verify that the height sensor is calibrated and that the height settings are established. See Seed Motor in Advanced Settings.
EPG must be active.
|
Electric Power Generation (EPG)— toggle button gives you quick access to engage the EPG system. |
ON/OFF |
NOTE: The toggle button does not appear when the EPG requirement is met or when the EPG is engaged.
A Target Population must be entered and selected.
Wheel motion must be detected.
You must be within the field boundaries.
|
Advanced Settings— access further adjustments and less common settings. |
Advanced Settings |
