Table of Contents

Create Driven Headland

Record a new driven headland.

GPS Offset Point

Select GPS to use the machine receiver as the offset point.

To draw the headland on either side of the machine receiver, set the offset location and the headland offset.

Select the Offset Location toggle to set the offset to either right or left of the machine.

NOTE: When the offset is set to 0.0, Offset Location toggle is disabled.

Select the Headland Offset input box to enter the offset distance.

Implement / Work Point Offset Point

Select Implement / Work Point to use the implement work point as the offset point.

NOTE: Implement / Work Point is selected by default when an implement is present in Equipment Manager.

To draw the headland on either side of the implement, set the offset location and the headland offset.

Select the Offset Location toggle to set the offset to either right or left of the implement.

Select the Headland Offset input box to enter the offset distance.

NOTE: Implement / Work Point default offset is equal to half of the implement working width in the Implement Profile.

Recording Driven Headlands

Select the Start Recording button to begin recording the headland.

Start Recording

Drive the machine along the boundary.

Select Pause button to pause recording.

Pause

NOTE: Pause recording to maneuver the machine without recording the headland. A straight line is drawn between where recording was paused and where it was resumed.

Select Cancel button to discard the headland.

Cancel

Select Save button to keep the headland.

Save

NOTE: Only one headland is allowed per boundary. If a new headland is created, the old one is overwritten.