Table of Contents
Table of Contents
Automation Status is used to determine if the requirements to operate AutoTrac Turn Automation have been met.
|
Automation OFF - The turn automation master toggle is off. |
|
|
Not Ready - One or more turn automation requirements are not met. Error Detected - System error detected. Disengaged - Turn automation has been disengaged. Message displays reason for disengagement. |
|
|
Ready - Turn automation is ready for operation. Press resume switch to enable turn automation. |
|
|
Active - System is in operation. Message displays the action being performed by turn automation. |
|
|
Active - System is in opearation, but a condition requires the attention of the operator. These include:
|
|
Turn automation must be on.
iTEC master must be on.
Either straight track, AB curve track, or AutoPath guidance method must be selected.
NOTE: Ensure that the AB curve track is generated across the entire field. Gaps in the guidance track may cause issues with AutoTrac Turn Automation functionality.
NOTE: AutoTrac Turn Automation is not compatible with machine access tracks.
Headland sequences must be defined.
Field boundary and headland boundary information must be complete.
Implement profile requirements must be met.
NOTE: Center of rotation measurement is required for any implement connected while AutoTrac Turn Automation is in use.
Machine profile requirements must be met.
Turn automation must be on.
AutoPath must be activated.
Either straight track, AB curve track, or AutoPath guidance method must be selected.
NOTE: Ensure that the AB curve track is generated across the entire field. Gaps in the guidance track may cause issues with AutoTrac Turn Automation functionality.
NOTE: AutoTrac Turn Automation is not compatible with machine access tracks.
Field boundary and headland boundary information must be complete.
Machine profile and header profile requirements must be met.
|
Requirement Met - Turn automation requirements are met. |
|
|
Requirement Not Met - Turn automation requirements are not met. |
|
|
View Application - Select to open application where turn automation requirements are not met. |
|
