Table of Contents
Table of Contents
Field Totals tab displays totals, such as Area Worked, Rate, and Total Applied, for the active field and operation.
|
Location - Use Location to set the client, farm, and field name. The selection is saved in the Fields application. |
|
|
Edit - Select Edit to open the Work Setup application. |
|
If multiple work operations are recorded, select the toggle to choose an operation type.
If multiple varieties or products are recorded for an operation, separate totals for each are listed after the field totals.
Area
Area is the total area that was worked while work recording was on. The calculation is based on working width, ground speed, and time worked.
Area Remaining is the area of the field that has not yet been worked. The calculation requires an exterior boundary and takes into account interior boundaries.
Time
Time is the amount of time work recording has been on for the current operation, measured to the tenth of an hour.
Time Remaining is the estimated time to finish working the field based on the remaining area and the time taken to work the completed part of the field.
Rate
Rate is the total number of seeds or product applied divided by area worked.
Total Applied
Total Applied is the total number of seeds or product applied.
Product
Product Remaining is the amount of product required to complete work. It is calculated by multiplying the area remaining and the rate.
NOTE: When using a tank mix, the amount listed is the whole tank mix and not the individual ingredients.
Fuel
Fuel is the amount of fuel consumed while recording work.
Average Rate (L/100m) - Specialty Sprayer Only
Average Rate is the total amount of product applied over the distance traveled.
See & Spray - Area
Area Worked is the area that the boom has passed over while work recording was on and spray method was either See & Spray or broadcast mode.
Area Applied is the area that was actually sprayed with product. With See & Spray, unsprayed area does not count toward Area Applied.
NOTE: If See & Spray detects a low percentage of targets, then the area applied should also be low.
Percent Applied is the area applied divided by the area worked.
See & Spray - Average Rate
Average Rate is the rate divided by the area applied.
Weed Pressure - All Weeds
Weed Pressure is the percentage of vegetation coverage by plants that See & Spray identifies as weeds.
Weed Pressure - Broadleaf
Broadleaf Weed Pressure is the percentage of vegetation coverage by plants that See & Spray identifies as broadleaf weeds.
Bales
Total Bale Count is the number of bale tie events that have occurred.
Average Bale Throughput is Total Bale Count divided by Time Worked.
Average Bale Yield is Total Bale Count divided by Area Worked.
Mass
Total Wet Weight is the total mass of crop that has been recorded.
Total Dry Weight is the calculated mass of Total Wet Weight that has been adjusted for moisture content.
Average Throughput is Total Wet Weight divided by Time Worked.
Average Wet Yield is Total Wet Weight divided by Area Worked.
Average Dry Yield is Total Dry Weight divided by Area Worked.
Moisture
Average Moisture is the average of all moisture readings.
Modules for this application can be added to run pages using Layout Manager.
