Machine Profile Product Applicator

Machine Profile settings are important for accurate performance of John Deere AMS applications, such as AutoTrac and Section Control.

Items accessible on the Machine Profile page:

Profile Name - Select to enter a profile name for the machine.

Product Applicator Type - Select the machine type.

GPS Lateral Offset - Measures lateral distance (left or right) from center line of machine to center of GPS receiver.

GPS In-line Offset - Measures in-line distance from center of non-steering axle on machine to center of GPS receiver.

GPS Height - Measures vertical distance from GPS receiver to ground. Measure from top of green portion of GPS receiver to ground.

Working Width is the width of the area worked on each pass through the field. It is used to create coverage maps and calculate area worked.

The following applications require Working Width:

Work Point is the distance from the center of the rear axle to the location where product is applied.

The following applications require Work Point setting:

Use work recording to select the desired recording source.

Select Save button to store settings from all tabs and close Machine Profile application. Selecting Save is not required when switching between tabs.

Default sprayer profile settings are stored in sprayer control units. Changes to these settings are stored in the display.

To reset profile to factory defaults, select Reset Profile button.