Table of Contents
Table of Contents
Information and Settings page allows you to access further adjustments and less common settings.
NOTE: Moisture Base Profile only appears if a constituent sensor is detected.
|
Moisture Base Profile - Select the moisture base profile. |
|
|
Enable AutoPath Recording Status - Select to display a list of AutoPath recording requirements. |
|
NOTE: Operator license and conditions are enabled by default on self-propelled sprayers.
|
Enable Operator License - Select to enable operator license. |
|
|
Enable Conditions and Work Notes - Select to enable field conditions, weather conditions, and work notes. |
|
|
Automatic Work Plan Activation on Field Change - Select to automatically activate a work plan when the machine enters a field for which a work plan exists. |
|
NOTE: If there are multiple work plans for the same field, or other conflicts emerge, a popup prompts the operator to manually select a work plan.
|
Remove Completed Work Plans - Select to automatically delete planned work that has greater than 90% coverage or incomplete work that has not been used in at least two weeks. |
|
|
ISOBUS Documentation Mode - Turn ISOBUS documentation ON and OFF. |
ON / OFF |
NOTE: ISOBUS Documentation Mode must be ON to record ISOBUS task totals.
ISOBUS Totals Request
|
Controlled by Display (Recommended) - The display requests ISOBUS totals information from the implement at regular, frequent intervals (more frequent). |
|
|
Controlled by Implement - The implement sends ISOBUS totals information to the display based on parameters set by the implement controller (less frequent). |
|
