Table of Contents

AutoTrac Controller WAS Calibration

This procedure calibrates the AutoTrac Controller wheel angle sensors (WAS) to maximize guidance performance.

Perform calibration when:

Procedure Requirements:

Procedure Overview:

  1. Select Start button to begin calibration.

Start

  1. Follow messages to complete procedure.

  1. Confirm calibration by selecting Save button and to return to Diagnostics Center Readings.

Save

If Calibration Fails:

  • Verify that all requirements have been met.

  • Select Retry button to repeat the calibration.

Retry

  • If calibration fails twice, see your John Deere dealer or other service provider.

Select Cancel button to return to Diagnostics Center Readings.

Cancel