Table of Contents
Table of Contents
AutoTrac Turn Automation contains advanced guidance and speed control, IMS functions, and iTEC functions. When using AutoTrac Turn Automation on tractors with IMS or certain tractors with iTEC, the tractor IMS or iTEC must be disabled.
IMS Active - This message displays when the tractor IMS (implement management system) is active.
Use the following table to determine whether the tractor iTEC must be disabled.
|
Machine Model |
Serial Number |
|
6R |
–20100 |
|
7R |
–10001 |
|
8R |
–67001 |
|
8RT |
–909001 |
|
9R |
–10000 |
|
9RT |
–904000 |
NOTE: If IMS or iTEC is enabled, the iTEC master switch on the universal display is automatically turned off and AutoTrac Turn Automation setup cannot be completed.
Depending on the machine, disable tractor IMS or iTEC either under iTEC on the CommandCenter or on the right-hand side console. To use IMS or iTEC on the CommandCenter again, disable AutoTrac Turn Automation and iTEC on the universal display.
To prevent the implement from steering during end turns while running Active Implement Guidance and AutoTrac Turn Automation, adjust the following settings:
Application Controller 1100 (UCC1)
Select Application Controller 1100 in the ISOBUS VT application.
Select either the Implement Steer Setup button or the Implement Shifter Setup button.
Select "AT + Imp Work State" from the Requirement to Engage drop-down menu.
Application Controller 1100 (UCC2 S.N. PCXL01C201000—)
Select Application Controller 1100 in the ISOBUS VT application.
Select the Active Implement Guidance softkey.
Select Automation Options under the Setup tab.
Select the "Disable steering when work recording off" checkbox.