Table of Contents

New Circle Track Edge

Edge represents outer boundary of a center pivot. It is displayed as an orange line on guidance map.

NOTE: If track spacing and working width are the same, end of implement will line up against the edge.

Creating a circle track edge allows guidance lines to be generated starting from edge. Otherwise guidance lines are generated starting from center of pivot.

If a new track spacing is entered, guidance lines are adjusted to match new value. If edge is deleted, guidance lines are created from center outward.

NOTE: Edge information cannot be used on GreenStar 3 Displays.

 

If circle edge is not wanted, select No Edge radio button and select OK button.

To create a circle edge:

  1. Select radio button to Add Edge to circle track.

  2. There are two methods to set edge location.

    1. If distance from center of pivot to edge is known, select edit button to enter value. Entering a value of 0.0 does not create an edge.

    2. Otherwise, move machine so receiver is at circle edge. Select button to Set Edge to Current Distance.

  3. Select OK button to save edge information.