With this button selected while recording, a line will be created that follows the machine.
This button creates a straight line between when button was selected until it is switched.
Curve mode is automatically selected at the beginning of a recording session. After recording starts, you can toggle between curve and straight.
|
With this button selected while recording, a line will be created that follows the machine. |
|
|
This button creates a straight line between when button was selected until it is switched. |
|
Example: When approaching and navigating around an obstacle, select straight button. Straight line segment connects points where straight button was selected.
Allows the next pass to be propagated without a deviation or gap around obstacle as occurs when recording in curvy mode.
NOTE: Button in use appears darker.
|
Start recording button |
Start |
Press Start button to begin recording a guidance line.
Curve and straight segment buttons can be switched as needed while recording.
Done button saves Track, and five projected lines are generated in both directions of initial track. Straight line extensions of 91 m (300 ft.) are added to beginning and end of paths.
NOTE: Cancel button ends session without saving guidance line.
